How can I get rid of the PUMP value in the report I only need Heat Reject and Miss Equipment ..I removed from the simulation but still shows up ?
It is Pump/Aux value. There must be a auxiliary load someplace if there are not any pumps in the model.
Timothy Howe, MS, LEED? AP
Check your pilot lights. If you have fuel fired equip it defaults to having a pilot light "load". Under airside, heating, unitary power, furnace fuel aux.
Alan Crittendon, PE, LEED AP
Allan
I do have pumps in the model but I do noit want to take in account their energy usage and not to show up in the report. Thanks
Alex
Uncheck shown parameter below.
[cid:image001.png at 01CB8FDE.C4492230]
It is Pump/Aux value. There must be a auxiliary load someplace if there are not any pumps in the model.
Timothy Howe, MS, LEED? AP
Check your pilot lights. If you have fuel fired equip it defaults to having
a pilot light "load". Under airside, heating, unitary power, furnace fuel
aux.
Alan Crittendon, PE, LEED AP
Allan
I do have pumps in the model but I do noit want to take in account their energy usage and not to show up in the report.
Thanks
Alex
Uncheck shown parameter below.
[cid:image001.png at 01CB8FDE.C4492230]
Timothy Howe, MS, LEED? AP