Dear eQuest users,
I have modeled a building in eQuest with a lot of glazing on the south end. In an effort to evaluate the effect of the building orientation, I have created a parametric run to rotate the building azimuth by 180 degrees. When I run the simulation, it seems to go through all the motions correctly. It runs the simulation for the baseline case, and then again for the case with the building being rotated by 180 degrees. Once the second simulation is complete, however, I get the following error messages, and it kicks me out of eQuest:

[cid:image001.png at 01CA2D50.08CF08E0]

[cid:image002.png at 01CA2D50.08CF08E0]

Has anyone else encountered these issues with eQuest. I would think that this was a relatively simple Parametric run to evaluate. Any help at all is greatly appreciated. I have attached the associated files. Thank you in advance.

Seun Odukomaiya, LEED AP