Hello,
I'm modeling a 6 story building from plans. All floors are equal from the
rear. The first two floors come out 165' and have the same footprint. But
floors 3-6 come out 115'. The 6th floor has a 25'x30' uncovered patio. I
used the custom zoning pattern to create the layout of the footprint for
each floor. When I look at the 3D model, I see the outlines of the
different footprints for floors 3-6 correctly. But what should be an
exterior wall is showing as an interior adiabatic wall.
1. How do I get the program to treat these interior walls as an exterior
wall?
2. How do I get rid of the walls that followed floors 1 and 2 but are
non-existing for floors 3-6?
--
Kind Regards,
Mark Stout, President
HERS I & II, BPI BA, MFBA, RESNET HERS
Lighting & Mechanical Acceptance Testing
CALGreen Inspector/Plans Examiner
Apollo Energies, Inc.
888-614-8338 x101 Office
888-614-8338 Fax
916-240-2850 Cell
www.apolloenergiesinc.com
Follow us on Twitter
Subscribe to Apollo Energies Daily News
DISCLAIMER: I am not an attorney nor am I an accountant. The information
and/or opinions expressed by myself or my affiliates should not be
considered nor are they intended to provide legal or financial advice to
any individual or entity. The information contained in this email is for
general information purposes only. Any reliance you place on such
information is therefore strictly at your own risk. Apollo Energies Inc.,
urges you to consult with your own legal and/or financial advisers before
taking any further actions based on information provided in this
correspondence.
