Hi everyone,
Hope everyone is doing well.
I am working on one school facility project where I need to run couple of ECMs for HVAC system type. One of the system that has been suggested by mechanical engineers is:
- The roof mounted solar thermal plate system will provide tempered hot water for the building central heating loop with a separately pumped glycol heat transfer system. Heat transfer will occur to the heating loop through a plate heat exchanger located in the mechanical room. The system will be available to provide heat to the low temperature heating loop & also DHW preheating.
I know eQuest cannot model solar thermals (it has PV modules though) for space heating. I know there is one website (from Canada) from where you can get hourly data for solar thermals & assign it to your eQuest model. The method need some post-process calculation and I need to understand more on this (which I cannot recall right now). Can someone please provide some inputs?
Thanks!
Harshul Singhal, LEED AP BD+C
Project Consultant
Thornton Tomasetti
386 Fore Street, Suite 401
Portland, ME 04101
T +1.207.245.6060 F +1.207.245.6061
D +1.207.245.6074
HSinghal at ThorntonTomasetti.com
www.ThorntonTomasetti.com
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
The information in this email and any attachments may contain
confidential information that is intended solely for the
attention and use of the named addressee(s). This message or
any part thereof must not be disclosed, copied, distributed
or retained by any person without authorization from the
addressee. If you are not the intended addressee, please
notify the sender immediately, and delete this message.
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>