Heat Recovery bypass dampers

2 posts / 0 new
Last post

Hello

I have couple of questions here in terms of HVAC modeling in eQuest:

1. How can I model heat recovery bypass dampers that can be opened during air-side economizer mode?

2. I have 2 systems in my model. ACB (active chilled beam) for 2 floors & VAV system for another 2 floors. I am recovering 10,000 CFM (ERV) through ACB system and now I want to recover 20,000 CFM from dedicated exhaust. For dedicated exhaust, I have created a dummy zone which assigned 20,000 at exhaust side. Now how can I recover heat from this dedicated exhaust. I tried to create a PSZ system just for this dummy zone and tried to recover heat through that but instead it's giving me high penalty. Minimum Outdoor air for this system is kept one. Is there any other way to do this heat recovery? How does it differ from glycol run around from dedicated exhaust to Outside air intake mixing unit?

3. How can I model wrap around heat pipe for chilled beam exhaust for my ACB system?

Any comments will be helpful! Thanks a lot in advance.

Harshul Singhal
Project Consultant
Thornton Tomasetti
386 Fore Street, Suite 401
Portland, ME 04101
T 207.245.6060 F 207.245.6061
D 207.245.6074
HSinghal at ThorntonTomasetti.com
www.ThorntonTomasetti.com

<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>

The information in this email and any attachments may contain

confidential information that is intended solely for the

attention and use of the named addressee(s). This message or

any part thereof must not be disclosed, copied, distributed

or retained by any person without authorization from the

addressee. If you are not the intended addressee, please

notify the sender immediately, and delete this message.

<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>

Harshul's picture
Offline
Joined: 2014-03-25
Reputation: 0