Hello,

I have been using eQuest for only the past couple of days. I have gone through and have simulated a 1 storey residential home in the schematic wizard without any major problems. However, I am now in the DD wizard and when I picked the pitched roof with an attic the wizard has drawn the ridge width wise rather than length wise. The building is 43.08 ft by 25.06 ft. The schematic wizard modeled it correctly and I was able to put hip ends across the 25.06 ft. The DD wizard is putting them across the 43.08 feet. I am not very knowledgeable with eQuest and I would like to avoid editing this in the detailed interface as much as possible. Any help is appreciated.

Arslan
0