To create performance curves, has anyone tried to use the "Performance Data" in eQuest (input screenshot shown below)? If you input all of the data, shouldn't it calculate the coefficients at the bottom or is there a way to assign these to equipment?
[cid:image002.png at 01CACCF9.546C57F0]
Thanks!!
KATIE L. M. TUTTLE EI, LEED(r) AP
Katie,
I don't believe the Equipment Performance Data has been fully
implemented yet. You still have to generate the curves on your own and
then input the coefficients into eQuest.
John T. Forester, LEED AP
I have created a custom performance curve for a water cooled chiller
that there were two options avilable, Curve Coefficient and Raw Data
Points. When you select Raw Data Points-like what you have done- there
is no need to calculate the curve coefficients and eQuest will calculate
them automatically.
Hope this helps.
Hassan Zareh, M.Eng., P.Eng., LEED AP