Dear eQuest User,

I am currently modeling a district cooling and heating system for
provided by a ground source heat pump.

By following the DOE 2.2 Volume 2 report, I managed to setup the system.
However I haven't been able to setup the Heating Input Ratio.

The PV-A Plant Design Parameters gives 0 for the rated heating capacity,
any idea where to enter this parameter.

*** PRIMARY EQUIPMENT *** RATED
RATED RATED

CAPACITY
FLOW EIR HIR AUXILIARY

EQUIPMENT TYPE ATTACHED TO (MBTU/HR)
(GAL/MIN ) (FRAC) (FRAC) (KW)

---------------- -------------------------------- ----------
---------- ---------- ---------- ----------

Heat pump

LOOP-TO-LOOP-HP CWL Coils 2.019
481.4 0.185 0.000 0.000

Ground Water Loop 2.468
548.0

HWL Coils 0.000
548.0

Regards,

NICOLAS MERCIER