Compliance Analysis Error

3 posts / 0 new
Last post

Hi all,

I'm working on my first LEED compliance analysis model and am trying to establish the baseline.  When I run the analysis i get the following error:

[Table look-up failed: a901-07_Envelope(1,4) evaluating rule: Look-up and default C-FFACTOR for slabs]

Would this occur from an error in the model definition?  I'm hoping someone can point me in the right direction.

marshall1111's picture
Offline
eQUEST User
Joined: 2011-05-03
Reputation: 0

Hi,

Can You Please help me?

When I am trying to run for baseline run I am getting error: Assign zone to baseline floor system: C Rule: E Val () error posting symbolic9 value 3.4126e-297) results to BDL.

I will be thankful to you for resolving the error.

Thanks & Regards,

Nimesh Prajapati

 

Thanks, Nimesh Prajapati (+91 9687133492) Design Engineer & Energy Modeller
Nimesh Prajapati's picture
Joined: 2012-03-03
Reputation: 0

Nimesh:  I would check the C-values in your walls/floors.  Your error seems to be a little different than the one I had.

UPDATE: I wanted to follow up on this error.  For some reason, the F-factors were not being added into the wall definition.  I wasn't able to fix it through data manipulation because eQuest does not allow you to manually edit the F factors.  I rebuilt the model, compiling after each screen.  The new model has the correct f-factors and runs well. 

marshall1111's picture
Offline
eQUEST User
Joined: 2011-05-03
Reputation: 0