Hi, I have a question about EIR modeling.
When I'm modeling the cooling unitary power and I load curves the curves to approximate VRF system(llike Mitsubishi guideline), I have to model with EER or IEER?
Another question I have is when you have a chiller equipment efficiency, you have to correct EIR?

Best Regards,

Juan Carlos Sanabria
Sustainability Department Project Engineer
Circuito

Main: +506 2243-1000
Direct: +506 2243-1069
juan.sanabria.fallas at jci.com
www.johnsoncontrols.com

Parque Empresarial Forum 1, Edificio H, Piso 2
San Jos?, Costa Rica

THIS MESSAGE MAY CONTAIN INFORMATION THAT IS PRIVILEGED AND CONFIDENTIAL. The information contained in, or attached to, this message is intended solely for the use of the specific person(s) named above. If you are not the intended recipient then you have received this communication in error and are prohibited from review, retransmission, taking any action in reliance upon, sharing the content of, disseminating or copying this message and any of the attachments in any way. If you have received this communication in error, please contact the sender immediately and promptly delete this message from all types of media and devices. Thank you.

Please consider the environment before printing this message