Dear all,
I am using the detailed data edit mode in eQUEST and I can?t change the
latitude, longitude and altitude. I go to the site properties, type my data
and then it goes blank again. This appears as an error when conducting the
compliance analysis and it doesn?t let me move on. Any suggestions? Thank
you very much.
Regards,
Eleni
The LEED compliance is not set up for international locations at this point.
Brian Fountain
Hi, Thanks for your answer.
Does that mean that eQUEST can't compare my building to a baseline building
as required for LEED EAp2 and EAc1?
Eleni Soulti
Not directly. However you can select a US location with the same 90.1 climate zone and run the compliance tool to get a start point for your reference building which you subsequently edit in the detailed interface.
------Original Message------
From: Eleni Soulti
To: Brian Fountain
To: equest-users at lists.onebuilding.org
Subject: RE: [Equest-users] Latitude and longitude values in eQUEST
Sent: Jul 19, 2012 2:21 AM
Hi, Thanks for your answer.
Does that mean that eQUEST can't compare my building to a baseline building
as required for LEED EAp2 and EAc1?
Eleni Soulti