Dear e-quest users,

I tried to make a very simple change in supply air temperature control, but obviously it is not working right. Cool control in Wizard was set to Constant and I want to change it to Reset based on outdoor air temperature in DD mode. I created cool reset schedules, set the cool control to reset and assigned cool reset schedules. However, instead of getting lower energy consumption, I have bigger cooling compared to constant control. I got the same results with another file. Basically, if I set the cool control in Wizard to reset, run the file, I get smaller cooling energy compared to constant control, which is what I expect to see. However, if I create schedules in DD, and set control to reset (the file was created with constant control in wizard) I get higher cooling energy consumption. What am I missing here?

Thanks for your suggestions.

Ana