Hi everyone,

I'm working on a loop-to-loop heat pump model. My hot water loop has a coil
load of 231.8 kBtu/h, from the SS-D and PS-D reports. To this loop, I have
710 kBtu/h of heat pumps and an 846 kBtu/h boiler attached, which reasonably
matches the primary number.

But, for some reason, the message below is telling me my secondary load is
10x the size that it actually is!

**WARNING*******************************************************************
***

Loop: Hot Water Loop heating capacity is smaller

than the secondary demand. Primary= -1537010.

Secondary= -2291187.

Does anyone happen to know where this secondary number actually comes from?

Thanks,

Shaun