When I select the ERV Device and specify Enthalpy Wheel, eQuest 3.65 hangs (and hangs the computer) for a seven minutes then reports "Maximum number of tracked modifications exceeded." Is there a setting that will minimize the amount of "hang time"? It is very annoying.
Thanks for any assistance!
Christopher Jones, P.Eng.
Tel: 416.644.4226 * Toll Free: 1.888.425.7255 x 527
______________________________________________________________________
NOTICE: This communication and any attachments ("this message") may contain confidential information for the sole use of the intended recipient(s). Any unauthorized use, disclosure, viewing, copying, alteration, dissemination or distribution of, or reliance on this message is strictly prohibited. If you have received this message in error, or you are not an authorized recipient, please notify the sender immediately by replying to this message, delete this message and all copies from your e-mail system and destroy any printed copies.
No,I think there are too many zones in your model ,which is the reason cause a long hang time.you can modify the input file directly, it will be very fast.
Yongqing zhao
Changsha university of science and technology.
????????
????????
"Jones, Christopher"???