system parameters

1 post / 0 new

Hi,

I modeled a building with 8 different cooling/heating systems each serving
to different zones. I used DD Wizard mode create the model, run the
simulation and compare my inputs at the detailed data edit mode. After this
check I figured out that in detailed edit mode couple of the systems
capacity and supply air values are almost half of what I defined at the DD
Wizard mode. Has anybody experienced the same problem and should I adjust
the capacities and supply air values at the detailed data edit mode again?

Thanks

Isa TAN, M.S., EIT

Isa Tan2's picture
Offline
Joined: 2011-09-30
Reputation: 0