I am encountering the following issue, when I perform the simulation on my model before it finishes a warning message pops up. It says that the output file name exceeds maximum 260 characters. Does anybody know how to fix this problem?
[cid:image001.png at 01CCCBA2.121EF160]
Best regards,
Alejandro
I believe that if you move the file so that the total file path does not exceed 260 characters, that this will go away. I have run into this issue in the past as well and that fixed it for me.
Danny
Either simplify the path to the file or reduce the filename?
I don't think there's an eQUEST setting to get around it.
Vikram Sami, LEED AP BD+C
Thank you very much to all who replied! It was only matter of changing the location of the folder to a shorter path.
Best Regards,
Alejandro Ibarra-Rovillard