Good Morning Sim Board,

I am working on a project where I am simulating a Desiccant Unit that is controlled off of a space humidity sensor. I began with the example file DesiccantCVRhZoneRHCtrl.idf from the support documentation with the current E+ install. Unfortunately the AIRLOOP associated with this example file is not quite the configuration I am looking for. My attempts at re-authoring my Airloop have proven arduous at best. I was hoping you folks could steer me towards some alternative example files. The specific AIRLOOP arrangement I am looking for follows this path:

OA Mixing Box > Gas Fired Desiccant Wheel > Supply Fan > Chilled Water Coiling Coil > Hot Water Heating Coil

Thank you,

Joshua W. Talbert P.E., LEED-AP