The eQuest Help menu states:
INDUCTION-RATIO
For IU systems only, the ratio of induced air flow to primary air flow. This
entry is applicable to the IU system type, but not to the variable-ratio
ceiling induction units used for subzone temperature control (SZCI system
type), which have a preprogrammed value of 1.0. The value input for
INDUCTION-RATIO applies to all zones in the system.
Can anyone tell me where to enter the Induction Ratio?
Thank you,
Paul Diglio, CEM, CBCP
Paul,
You can modify the Induction Ratio on the Systems -> Fans -> Flow Parameters tab for each IU system. IU systems have an INDUCTION-RATIO of 3.0 by default.
Regards,
Bill
William Bishop, PE, BEMP, LEED AP
Thanks Bill, I found it after I posted. My eyes weren't open this morning.
Regards,
Paul Diglio, CEM, CBCP