I have a model that I was running yesterday without any issues, but
today when I try to run the model it gives me the following error:

Forrtl: info (58): format syntax error at or near (Note: u-values
include outside air film)'//73X, "LOCATION OF ORIGIN'/51Xm 'GL

Has anyone experiences this error before? I tried restoring my folder to
an older version from when the model was running properly, but that didn't
work. I also tried running in Windows XP mode and that didn't work
either. I'm using eQUEST v 3.65.

Thanks,

*Mike Campbell, E.I.T., LEED AP O+M*
*Sustainability Specialist*
*Sustainable Solutions Corporation*
Office: 610-569-1047

Mobile: 609-923-1743
www.SustainableSolutionsCorporation.com
*Sustainable Solutions Corporation is WBENC and BCorp Certified.*

*This email message and any attachments are for the sole use of the
intended recipient(s) and may contain confidential and privileged
information. Any unauthorized review, use, disclosure or distribution is
prohibited. If you are not the intended recipient, please contact the
sender by reply email and destroy all copies of the original message and
any attachments.*