eQuest and DOE2.2 have dozens of defaults that are not displayed in the .inp file. You may not be getting the results you expect. I just found a way to display all the defaults used for a project.

You can?t do this in the eQuest interface. You have to run the file from the command line using DOE2.2. Edit the .inp file. At the top of the file is a section ?Abort, Diagnostics?. Add the command DIAGNOSTIC DEFAULTS ..
Then run the file. The .BDL file now shows all the keywords that are defaulted and their values.

Christopher Jones, P.Eng.
Tel: 416.644.4226 ? Toll Free: 1.888.425.7255 x 527

______________________________________________________________________
NOTICE: This communication and any attachments ("this message") may contain confidential information for the sole use of the intended recipient(s). Any unauthorized use, disclosure, viewing, copying, alteration, dissemination or distribution of, or reliance on this message is strictly prohibited. If you have received this message in error, or you are not an authorized recipient, please notify the sender immediately by replying to this message, delete this message and all copies from your e-mail system and destroy any printed copies.