Good Day,

This may seem like a simplistic question as I'm new to eQUEST.

I am familiar with different cooling systems but not so much heating
systems.

I need to add in a combined single zone DX Coil package with natural gas
used for heating, from the specs I have I assume it's a furnace with a hot
water coil.

It's a carrier.

However in Equest there isn't a combined system so I added in two systems
one for the Single Zone DX Coil Cooling only then added in a separate entry
for the heating as a furnace with a hot water coil.

I ran the model but when going into the detailed model I don't see the hot
water coil, if I add it into the heating tab then I need to add a hot a
water loop and there is none.

I might be totally off the mark here but am battling with this section, any
assistance would be great.

Thanks

Regards

DAMON LAPPING

Managing Consultant

damon at greenlogik.co.za

www.greenlogik.co.za |
www.pvsystem.co.za

T. +27 21 (0) 87 470 0650 F. +27 (0) 86 763 1323

C. +27 82 339 3865

UNIDO Certified Energy Management Professional

SA Green Building Council Existing Building Performance Accredited

Professional

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus