Hello eQuest Users,

I am using a parametric run to estimate savings associated with dual
enthalpy economizer versus drybulb economizer. In the baseline run, I have
the drybulb high limit manually set to 75?F. When I change economizer to
?dual enthalpy? in the parametric component, I would also like to reset the
drybulb high limit back to the eQuest default (which removes this input for
enthalpy economizer control). Is there an entry that can be entered into
the parametric component that resets the value to the eQuest default?

Any insight on restoring defaults for parametric run components is welcome.

John T. Forester, LEED AP