Dear All,

I am modeling a factory project. The site has 15 buildings in all. 7
of these buildings are ventilated using evaporative cooling (wet
ventilation system) and 8 are ventilated using dry ventilation system.
All these buildings are detached from one another and located in a
very discontinuous manner on the site.

The buildings which have wet ventilation system will have inside
temperature at 5 degrees less than the outdoor ambient temperature.

Please help me with the following,
1. How do I go about the modeling of evaporative cooling system for
the 7 buildings in the site ?
2. How should the temperature set point be done?

Any help and direction to solve this is genuinely and deeply appreciated.

Kindly let me know if any additional data is required for further
understanding or deriving the solution.

Thank you
Warm Regards,
Kirti

--
*Kirti Pabrekar - Patil*
M. Arch, LEED GA,
IGBC AP, GRIHA Trainer & Evaluator,

*Green is a commitment...not a competition*