Different Cases in eQuest modeling

1 post / 0 new

Dear Friends,

 

Can you please guide me on following cases:

 

1.      

In one Project We have different WSHP (Water Source heat Pump) units serving to three floors and there is one RTU which supplies ventilation air to WSHP units. I can model WSHP units in eQuest but how to model this RTU as it is not separate system?

 

2.      

In other Project We have combination of three AHUs - with only Chilled water coils (Two working + One Stand by) and one Precoil unit with Chilled water coils which supplies fresh air to these set of AHUs. What I had done is modeled combined capacity of AHUs (with adding cfm of both AHUs) for the area served, but then here is also question; how to model precoil unit?

 

3.      

We have Office areas which are served by AHUs as well as there is split AC in each office. as per my knowledge we can model only One HVAC system for single zone in eQuest or is there any other way where I can assign these systems and can model it?

 

Thanks,

Nimesh Prajapati

Thanks, Nimesh Prajapati HVAC Design Engineer & Energy Modeler (+91 9687133492) email: nimesh@engineersaid.com Skype: nimonicsone This email and any files transmitted with it are confidential and intended solely for the use of the individual
Nimesh's picture
Offline
Joined: 2012-10-06
Reputation: 1