Fellow eQuesters,

Could someone please advise me on the best way to model the following systems
in eQuest.

I have a multizone unit that serves all the zones in my building. However,
there are two zones that have a very high occupancy thus very high outdoor
air rate a couple of times a year (requiring ~ 2300 cfm extra than during
normal occupancy). I would like to serve these two zones using a dedicated
outdoor air system (single zone unit) that is enabled once the CO2 levels get
too high in the zones.

Should I set up the multizone unit to borrow conditioned OA from the
dedicated OA unit? If so, I'm not sure on exactly how this is done. Any
advice is greatly appreciated.

Thank you,

Kyle Nisonger