Dear all,
Can anyone please help me in the following caution?
In curve: Variable Speed Drive FPLR the dependent value is exceeding the
limits.
Value/Min/Max/First time: 1.257 0.100
1.000 12/31/24
This has been discussed earlier but the conversation has dropped without a
solution for this.
--
Best Regards
Dayani Nayantha
Dayani,
This is a frequent caution and the consensus seems to be that it should just be ignored. See the email below for a previous discussion. (Perhaps this is the discussion you mention.) Note that it is happening on the very last hour of the simulation so it has negligible impact on your energy results.
http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/2010-May/004322.html
Regards,
Bill
[Senior Energy Engineer 28Jun2012]