Matching Zone OA Flow Rates

2 posts / 0 new
Last post

My question is in regards to matching the zone level OA flows between
the design and baseline models. This particular project uses system
type 7 in the baseline model. Generally, I get both models to roughly
where I want them to be, and then take the zone level OA flows from the
design model SV-A reports and copy them into the baseline model. But
for some reason, this baseline model inflates any value I specify as the
zone level OA flow. I've never had this issue before and I even tried
specifying much larger OA flows (i.e. 4,000 cfm instead of 500 cfm), but
when I check the SV-A reports for the baseline, the OA flow values
listed are always higher than I specified. I've changed a number of
parameters, but I can't determine what's overruling my OA flow input.
The main air handlers in the models are 100% OA, but I've had 100% OA
AHUs in other projects and never had this issue.

Anyone have any suggestions?

Thanks in advance,

Scott

Scott Janssen's picture
Offline
Joined: 2011-09-30
Reputation: 0