Dear TRNSSYS User,

i am trying to run an active layer with an specific massflow rate of 15
kg/h m? (absolute value 654.15 kg/h). TRNBuild calculates a minimum
allowed massflow rate of 10.25 kg/h. (446 kg/h) ....so far so good.
But when I set this massflow rate in TRNSYS Studio via Input to the
wanted 654.15 kg/h I get following error

"specific fluid mass flow of active layer in surface 2 below minimum
value of16.26/m2h, increase the minimum mass flow rate or use
autosegmentation feature of TRNBuild for subdividing the surface."

This is a really strange behavior. The massflow criteria varies and
seems to depend on the inlet temperature.. I also tried autosegmentation
- I didn?t help, I got the same error message.
Please help me out here..

Thank you

Michael D?bele