I am in the early stages of learning eQuest and I am trying to model a high-rise (20 story) office building.

I am creating the building with the DD wizard. I expect to use the detailed interface but I seem to bog down once I get in that mode.

When I view the 3-D geometry in the building shell it only shows the bottom 2 floors and then the top floor with empty space in between. The component tree shows "mid-Flrs" but not the 17 floors I expect to see.

The HVAC system has dual duct air handlers serving a quandrant of each floor - 5 floors per AHU so 16 AHU's total.

What am I doing wrong here? How can I create these middle floors and add the AHU's?

Does anyone know of a training that will take me through a fairly complex project step-by-step and not just seperate disconnected tasks? I always seem to learn best when going through the entire process in sequence and I haven't found a source for this. Any help is appreciated!