I'm modeling an indoor pool, by creating a room that serves as my load on a pool boiler.  I've added the evaporative load to a misc load, and partitions for the transfer to the air as well as the adjacent room below that heat will be lost to.

I've then used a Radiation (Heating Only) system to account for the losses from the partitions.

I'm seeing the evaporative/misc load on my boiler, and I'm seeing a heat loss from the partitions in the Room Checksums output sheet, but I'm not seeing a load on the boiler for this loss.

Is there some trick to get this load to show up on the plant?

Thanks in advance