Hello All,

I was hoping someone out there has a recommendation on software to use for pinch analysis with plate and frame HX network optimization? I came across Canmet Integration software, and it appears to have a lot of functionality; however, its only available to Canadian engineers ?. Thank you in advance for any feedback and enjoy this fifth day of May.

Regards,

Janne Kairento PE, LEED AP

Project Engineer

[cid:image002.png at 01D0A4F9.D4C8DD50]

B2Q Associates, Inc.
100 Burtt Rd. Suite 212
Andover, MA 01810

Direct:

(978) 447 ? 5610

Mobile:

(978) 210 ? 7397

Main:

(978) 208 ? 0609

Fax:

(978) 719 ? 6339

jkairento at b2qassociates.com

www.b2qassociates.com<../../../../../jbliss/Desktop/www.b2qassociates.com>

The contents of this e-mail and any attachments are confidential and the property of the B2Q Associates, Inc. The e-mail contents are only to be used by the intended recipient of the e-mail. If you are not the intended recipient then use, disclosure, copying, distribution or reliance on the e-mail is prohibited. All professional advice from us should be obtained in writing (not e-mail).