The rooms tab in create rooms contains the data entered in the thermostat tab of create templates.

If templates are used properly, it is likely that most rooms will only require data entry in single sheet tab of create rooms

It is important to enter the exact length and width of a room in the single sheet tab of create rooms

If a room has a slab on grade floor, and that room has 10 rooms per zone entered under the rooms tab of create rooms, that room will be counted ten times but the floor will only be counted once.

When a floor multiplier is used, all rooms must be on the same system

Multiple miscellaneous loads may be added to a room under the internal loads tab of create rooms, but under create templates --> internal loads, it is only possible to add one miscellaneous load

Match the field to the appropriate field in create rooms. For example, wall construction type would be matched with walls, since it is under the walls tab of create rooms.

Match the following fields with their corresponding definitions

In the equation Sensible load = 1.085 * cfm * (T1 - T2), the number 1.085 is called the density specific heat product (DSHP). This number changes based on elevation and other factors. Trace uses this number to calculate the sensible load. In exercise 1, what DSHP did Trace use? (Hint: it is located in one of the first three reports in the upper left quadrant  of the design reports)

What design report gives you a list of all equipment modeled?

Which of the following reports gives the size of the ROOFTOPS heating and cooling coil? (The preheat coil is on the rooftop)

The size of the rooftop cooling coil can be accessed by the same checksum report regardless of system type?

Match the variable with the appropriate report:

In this image, how many single zone rooftops are modeled?

How many single zone rooftops are represented in the image below?