SI in eQUEST

4 posts / 0 new
Last post

Is there any possibility to change units type in eQUEST to SI?

Sincerely yours,
Mikhail Samoletov

MeDBeDb's picture
Offline
Joined: 2010-11-02
Reputation: 0

impossible

2010/10/21 ????????? ??????

grammy's picture
Offline
Joined: 2010-12-09
Reputation: 0

Hi Mikhail,

it is not possible at this time to use SI units in eQuest. Canada is
commissioning an SI version of eQuest, a.k.a. CANQuest that should be coming
out next year sometime. This version of the program will be based on SI
units for it's inputs.

Until then you will have to practice your conversions from SI to IP and vice
versa.

Pasha

2010/10/21 ????????? ??????

Pasha Korber-Gonzalez's picture
Joined: 2011-09-30
Reputation: 600

FYI--Here is the response that I received when I contacted NRCAN about the
future release of CANQuest which will be an SI version of an eQuest
interface.

Thank you for contacting CanmetENERGY http://canmetenergy.nrcan.gc.ca/eng/ a
Canadian leader in clean energy research and technology development.

CanQuest, a metric and bilingual variant of eQuest recently unveiled at the
eSim 2010 conference in Winnipeg, is slated to be available to the public in
the spring of 2011. Since the underlying DOE2.1e calculation engine for EE4
is no longer actively supported, EE4 is considered to be nearing the end of
its useful life; however, it will continue to be available from the
CanmetENERGY website.

My best regards,

Gayle Corkery

Pasha Korber-Gonzalez's picture
Joined: 2011-09-30
Reputation: 600