I am very new to this software and trying to figure out how to
model a heat recovery chiller that will replace a boiler on both
HW and DHW loops.
I would be happy if anybody could send me a file with some
example like that so I could figure out by myself.
Thank you!
youhave to go into detailed edit mode.? Get into the water-side HVAC section, then, on the component tree on the left of the screen, hover your pointer over your project name.? right click, select "new chiller", asnd you will find a heat recovery chiller is available.? Go through all of the menu items?to ?detail the chiller parameters
Thanks, I did that. I managed to connect the HR chiller to the HW
loop, but I am not able to make the HR loop feed the DHW loop.
:(
On Fri, 21 May 2010 07:30:37 -0700 (PDT), "Paul Brooks"
.com> said:
youhave to go into detailed edit mode. Get into the water-side
HVAC section, then, on the component tree on the left of the
screen, hover your pointer over your project name. right click,
select "new chiller", asnd you will find a heat recovery chiller
is available. Go through all of the menu items to detail the
chiller parameters