I have a project where none of the ES sim reports are being generated. The
list of sim reports skips from BEPU to LS-A. The project has no errors or
warnings. Does anyone have any ideas about why this might be happening?
Have you tried opening the .SIM file with a text editor?
I've found that the "View simulation results" tool within eQuest does
not always show all the reports.
I have run into this when using the refrigeration version of eQuest when there is a water heater present. If you delete the water heater the schedules show up. I have no idea why it is and have found no other solution for the issue.
I also found in an older version of eQuest that if you specified 2 or more
pumps for a particular component, then some of the reports would also not
show up. Resetting the number of pumps to 1 fixed the problem. I haven't
had this problem with eQuest 3.63.
Have you tried opening the .SIM file with a text editor?
I've found that the "View simulation results" tool within eQuest does
not always show all the reports.
Kind Regards,
Molly Curtz, P.E.
I have run into this when using the refrigeration version of eQuest when there is a water heater present. If you delete the water heater the schedules show up. I have no idea why it is and have found no other solution for the issue.
Maybe someone else out there knows why it occurs.
I also found in an older version of eQuest that if you specified 2 or more
pumps for a particular component, then some of the reports would also not
show up. Resetting the number of pumps to 1 fixed the problem. I haven't
had this problem with eQuest 3.63.
--
Karen
That was the problem, there was no utilty rate defined for that meter.
Thanks,
Rob
In this case it was because there was no fuel rate defined for the meter.
Thanks,
Rob