simulation - loop error

2 posts / 0 new
Last post

Hello,

When I try to simulate the model, a error message "loop has zero flow" pop-up. The error detail in ATTN simulation messager is "Loop: Hot Water Loop has zero design flow.Check input for consistency, or specify design loads.". How to handle it?

Thanks in advance.

Yanjun

Yanjun Cui's picture
Offline
Joined: 2011-09-30
Reputation: 0

Yanjun:

Is your loop connected to any load? Check the tree directory on the left side of the scrren.

John Aulbach

John Aulbach's picture
Offline
Joined: 2011-09-30
Reputation: 1