Thanks Julien
it works, i think it is a bug because i encount this tow times, the first situation is that i change glass parameters, if i go back, the error will not happen. and the second situation is about secondary chilled loop creation, if go back to primary loop, it also work normally.

Regards
Tiejun

I think it is a bug of eQUEST 3.65.Because I can see that this error is launched by Fortran.It is a runtime error.

Sincerely!

Yongqing Zhao

------------------ ???? ------------------
???: "Julien Marrec";
????: 2014?10?17?(???) ??4:38
???: "tiejun hu";
??: "equest-users at lists.onebuilding";
??: Re: [Equest-users] Strange error when running simulation in equest3-65

Hi,

I got this type of errors several times too, and I suspect this is not really a syntax error in the inp file since usually closing equest, logging off windows and on again fixes it.

It's annoying but I haven't found why it's doing that.

best,
Julien

--
Julien Marrec, EBCP, BPI MFBA
Energy&Sustainability Engineer
T: +33 6 95 14 42 13

LinkedIn (en) : www.linkedin.com/in/julienmarrec
LinkedIn (fr) : www.linkedin.com/in/julienmarrec/fr

2014-10-17 10:30 GMT+02:00 tiejun hu :

Does anybody encount this error?
it shows a error shown in the first attached picture when running simulation, then i click "done", it shows the sencond attached picture, if i close it, the software will exit.
Is it a bug or some setting problem?

Best Regards
Tiejun

_______________________________________________
Equest-users mailing list
http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
To unsubscribe from this mailing list send a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG