LEED Analysis Errors

3 posts / 0 new
Last post

Dear eQuest Users,

I have a question concerning the LEED Analysis errors. I just try to learn
about LEED Analysis for the given manual. My analysis runs keep receiving
the errors as follows: Assign zone to baseline floor system: CRule::Eval()
error posting symbolic (value 1.26508e-294) result to BDL. For the model, I
develop a simple rectangle five-story building. There is no error detected
in BDL and simulation.

I would like to thank you very much in advance for your kind helps. I am
looking forward to hear from you soon.

Best regards,

Om

KC's picture
KC
Offline
Joined: 2011-09-30
Reputation: 0

Om,

They are coming out with a patch for that error. I don't know if it has been
released yet.

Thanks,

PETER HILLERMANN

Peter Hillermann2's picture
Joined: 2011-09-30
Reputation: 0

Just for the purpose of generating your baseline model change all the Zone
types of your unconditioned spaces and plenum spaces to conditioned spaces.
Next generate your baseline model and then switch the spaces back. You can
do this on the Air Side HVAC -Basic specifications-Spread sheet under zone
type. It takes just a minute or two for the work around. This works until
they perfect the patch.

JAMES F. GEERS

James Geers's picture
Offline
Joined: 2011-09-30
Reputation: 0