Greetings everyone,
Since I am quite new on eQuest, this question can be lot simple for you but
I'd be happy if you could write a couple of sentences for me.
I am trying to make ready a CAD project for creating eQuest foodprint. I
drawed the footprint and zones' boundries on the CAD file with polyline
using a new layer. After that I switched off all the other layers except
the new layer I created, I opened equest . When I try to create the
footprint and zones using that CAD file it was not possible to SNAP it.
What do you think about how it could be?
--
----------------------------------------
Murat NAYAL
----------------------------------------
Murat Bey,
try to adjust snap priority : CAD as 1st, Polygon as No Snap and Grid as No
Snap?
You can also try to change the Snap Ranges. I think this can help you.
Best regards,
Utku Simitli
Hello again,
My previous question was answered. Thank you again. My second simple
question is how I can change the origin of my CAD drawing to (0,0)?
Thanks in advance.
Murat