Hi
I'm trying to run a compliance analysis but get the message:
Evaluating rulelist 'CreateBaseCentralPlant'
Rule ID 345 on [loop]
And then the program hangs.
Has anybody else seen this before?
Shaun Martin LEED-AP, BEMP
Principal
Shaun Martin Consulting
#90 - 425 Carrall Street
Vancouver, BC V6B 6E3
p. 604-789-1095
Shaun,
Have you tried a different version of 3.65 to see if the error is consistent in different versions?
I found that 3.65-b7163 produced bugs during the Compliance run but 3.65-b7158 ran fine using the same project.
[cid:image003.png at 01D09C46.E75BA0D0]
Christopher Jones, P.Eng.
Senior Engineer
WSP Canada Inc.
2300 Yonge Street, Suite 2300
Toronto, ON M4P 1E4
T +1 416-644-4226
F +1 416-487-9766
C +1 416-697-0056
www.wspgroup.com
Thanks Chris,
I tried 3.64 and 3.65 and got exactly the same result. The conversion
would hang at Rule ID 345. (It would certainly be nice to know the wording
behind these rules.)
I did solve the problem though. The model had a lot of interesting
mechanical features so I replaced all of the waterside and airside systems
with simple systems, one boiler, one chiller, VAV/RH everywhere, and the
conversion ran.
Cheers,
Shaun Martin LEED-AP, BEMP
Principal
Shaun Martin Consulting
#90 - 425 Carrall Street
Vancouver, BC V6B 6E3
p. 604-789-1095