Dear All,
I wonder, can the whole building be rotated 90, 180 and 270 degree in
Detailed Data Mode? If I switch back to Wizard Data Mode and change
orientation, the parts and pieces edited in Detail would be gone. Is there
any way to make rotation easy?
Thank you,
Jing
--
PhD Candidate, LEED AP BD+C
School of Architecture and Urban Planning
University of Wisconsin-Milwaukee
Sure , do it Parametrics. Run 1 Azimuth make 90 deg, run 2 180, always making the base run is your reference.
Sent from Yahoo Mail on Android
On Wed, Dec 20, 2017 at 1:31 PM, Jing Hong via Equest-users wrote: Dear All,
I wonder, can the whole building be rotated 90, 180 and 270 degree in Detailed Data Mode? If I switch back to Wizard Data Mode and change orientation, the parts and pieces edited in Detail would be gone. Is there any way to make rotation easy?
Thank you,
Jing
--
PhD Candidate, LEED AP BD+C
School of Architecture and Urban PlanningUniversity of Wisconsin-Milwaukee
_______________________________________________
Equest-users mailing list
http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
To unsubscribe from this mailing list send? a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
Absolutely.
The keyword is AZIMUTH.? It is found under the Building Data? on the
Building Shell tab of the detailed interface:
The easiest way to do the 3 rotations is to change the AZIMUTH to 90,
180 & 270 in parametric runs:
Thank you Brian and John! I?ve figured it out.
Jing
On Wed, Dec 20, 2017 at 9:20 PM Brian Fountain via Equest-users <
--
PhD Candidate, LEED AP BD+C
School of Architecture and Urban Planning
University of Wisconsin-Milwaukee